QUICK-PITCH STANDARD KIT
The Standard kit is where every Quick-Pitch floor starts. A Center Ring sits around the drain, and the tapered float sticks slot into it and run out to the walls. Pack mortar between the sticks and screed (level it off) across their tops, and the floor comes out at the right slope every time. It fits most showers, with walls up to 36 inches from the drain in any direction, and works with every waterproofing method.
- Built-in pitch sets the recommended slope, with no special skills needed
- Center Ring holds the sticks in place around the drain
- Lightweight, reinforced plastic that won’t rot
- Works with every waterproofing method
- 6 tapered float sticks
- 1 Center Ring
- Complete instructions
- Stick size: 1 in. to 1 3/4 in. tapered × 36 in. long
- Slope: 1/4 in. per foot
- Best for: walls up to 36 in. from the drain in any direction
Quick-Pitch Extra Float Stick KIT
An add-on pack of the same sticks that come in the Standard kit. Add them when you’d like more sticks or have an irregular, odd-shaped shower. They also replace the Standard kit in linear drain showers, where there’s no Center Ring.
- Same sticks as the Standard kit
- For irregular, odd-shaped layouts
- Replaces the Standard kit in linear drain showers
- Works with every waterproofing method
- 4 tapered float sticks
- Instructions
Quick-Pitch Standard Kit (QPK-101), or on its own in linear drain showers
- Stick size: 1 3/4 in. to 2 1/2 in. tapered × 36 in. long
- Best for: walls more than 36 in. from the drain
- Continues from: 36 in. to 72 in. from the drain
QUICK-PITCH EXTENDED FLOAT STICKS
An add-on that picks up where the standard sticks leave off. Each stick continues the same slope from 36 inches out to 72 inches from the drain, for larger shower floors. Cut them to the length you need.
- Continues the slope seamlessly out to 72 in.
- Easy to cut to length
- Built-in pitch, with no special skills needed
- Lightweight, reinforced plastic that won’t rot
- 4 tapered Extended sticks
- Instructions
Quick-Pitch standard 36 in. float sticks (attaches to the end of the stick)
- Stick size: 1 3/4 in. to 2 1/2 in. tapered × 36 in. long
- Best for: walls more than 36 in. from the drain
- Continues from: 36 in. to 72 in. from the drain
How It Works
Three steps to a perfectly sloped floor
01
Set the center ring
Place the Center Ring around the drain, on top of the drain’s clamping bolts. It marks the low point of your floor.
02
Snap in the sticks
Fit each stick’s tab into one of the ring’s 24 slots and run it out to the wall. Add Extended sticks if a wall is more than 36 in. away.
03
Pack & screed
Fill between the sticks with dry-pack mortar (4 parts sand to 1 part Portland cement) and screed across their tops for a true 1/4 in.-per-foot slope.